Common problems and treatment of electric roller

When we apply the electric roller, it may be due to some errors in the actual operation, or because we do not do a good job in the maintenance work in the process of ordinary application, then the equipment is likely to have some various problems. Let's take a look at some difficult problems that the equipment is likely to produce and have solutions.

In the process of application, if we find that there is oil leakage at the part of the junction box, we must first check whether there is too much oil added. If it is not because of this problem, we must check whether the sealing ring is damaged. The rotating part of the bearing end cover will also have oil leakage. In this case, it is necessary to check whether the skeleton seal of the equipment application has been seriously damaged. It is necessary to tighten the spring ring and then check whether there will be oil leakage. If the electric roller or oil leakage, it is necessary to remove and replace a new seal ring.

If the noise of the equipment is very large when it is running, it may be because the characteristics of the support frame are too weak to withstand the operation regulations of the equipment. If the noise is too large, the stiffness of some equipment must be improved at this time. Generally, the noise will be reduced a lot after lifting

Some equipment is still not rotating after turning on the switching power supply. It must be considered whether the power plug sequence is wrong. In the process of inspection, it must be ensured that it comes from turning off the power supply.

The above explanation is the solutions to some common problems of electric roller. In fact, many of them are due to our failure to do a good job in daily maintenance in the process of ordinary application. Therefore, it also reminds us to pay attention to doing a good job in maintenance in the process of ordinary application, so that we can limit the service life of the equipment in the long run.